PLUS+1 Software > Telematics

How to open ports 443 and 60100 (WS Danfoss Telematics)

(1/2) > >>

spittet:
Hi,

I downloaded the "Danfoss Telematics Solution PLUS1 Service Tool Drivers" to be able to do a remote connection with a WS403 unit and I can't connect because the Network Validation cannot open ports 443 and 60100.

I tried to do some port forwarding with our IT guy and we also make sure that there are no firewall activated and we always get the "The required ports (443 & 60100) are not open. Check the Internet connection." We even tried a DMZ to forward all the external requests to my computer local IP and the ports were still closed.

What are the next steps? The WS403 user manual doesn't have this type of info.

Thanks!

Sam

ssutherington:
The portal is down for maintenance this weekend. Try again once it is up and running.

You can check it's status at the link below.

https://danfoss.proemion.com/portal/

spittet:
Ok, now at least, I can login and I can see my remote machines in the window. But when I try to connect to a machine, I get error 24 : Device password request time out. Most likely because device is offline.

I know the machine is not offline because I can see it online in the Machine Window.

Maybe the timeout delay is too short. Can it be increased?

Still, the port check tell me that my port 60100 is closed. How can I open it. I already forwarded the 60100 port to my computer IP address. I have remove all my firewalls on  my computer. What else can I do?

Sam

Thomas:
Hello Spittet!

I have asked helpdesk to contact to you directly resolve this.

Best regards // Thomas

spittet:
Hi,

Any news on this? I saw that a new ticket has been created, but I don't have any news since then.

Let me know!

Thanks!

Sam

Navigation

[0] Message Index

[#] Next page