PLUS+1 User Forum

PLUS+1 Hardware => Controllers => Topic started by: MimmoA on July 10, 2013, 06:13:56 PM

Title: how to connect controller/computer
Post by: MimmoA on July 10, 2013, 06:13:56 PM
Hello,
I'm new in Sawer-Danfoss device,
I have a simple ( maybe stupid ) doubth that is blocking me,
finally i ve my hardware,it's a controller MC050-010,but i dont know how to fisically connect it with my computer,
do I need any cable/wire to do this?
I read something about a GC 150 gateway,is this what i need?
Thank you so much
Regards
Title: Re: how to connect controller/computer
Post by: Brian Bandura on July 10, 2013, 06:17:50 PM
Yes, you need a Canbus gateway of some sort, the CG150 is cheap and works well.  you build and compile your program, then download it to the controller with the gateway and service tool. You can also watch setpoints, change parameters with service tool.

Good luck!

Brian Bandura
Title: Re: how to connect controller/computer
Post by: Daniel on July 11, 2013, 08:25:44 AM
Hi MimmoA

There is a free e-learning course available on Sauer-Danfoss' webpage, which could be a good start for you.
You can also sign up for a face to face training session where you will learn all fundamentals in how to use PLUS+1 GUIDE and Service Tool. On the link below you will find more information about dates and contacts for training sessions and also how to access the e-learning.

http://www.sauer-danfoss.com/Products/MobileElectronics/PLUS1Guide/PLUS1GuideSupport/PLUS1Training/index.htm (http://www.sauer-danfoss.com/Products/MobileElectronics/PLUS1Guide/PLUS1GuideSupport/PLUS1Training/index.htm)


Best Regards
Daniel
PLUS+1™ HelpDesk