PLUS+1 User Forum

PLUS+1™ Software => General controls => Topic started by: bgtwuk on January 02, 2016, 06:07:56 PM

Title: Frequency on Multifunctional Pin
Post by: bgtwuk on January 02, 2016, 06:07:56 PM
Happy New Year Gents

If I am sending pulses to a Multi input pin, is the module or controller doing the math to allow a readable frequency value  ???


bgtwuk
Title: Re: Frequency on Multifunctional Pin
Post by: BRIan on January 04, 2016, 12:12:45 AM
Yes it is.
If you only need low resolution or there are plenty of pulses per rev, use the FREQ signal otherwise use PER to get decimal points of Hz.