PLUS+1 User Forum

PLUS+1™ Tools => PLUS+1™ Service Tool => Topic started by: deyan.dimitro on January 16, 2019, 12:43:27 PM

Title: Danfoss temperature sensor in Plus+1 Service Tool
Post by: deyan.dimitro on January 16, 2019, 12:43:27 PM
Hello,

i have a temperature sensor connected in ECU. Input pin is C1p27.Ohm and unit is Ohm. I must not change nothing in GUIDE Project File.

Can i get the information from this pin but in degrees in Service Tool?
I have Danfoss temperature sensor table.
Title: Re: Danfoss temperature sensor in Plus+1 Service Tool
Post by: oiltronic on January 24, 2019, 08:46:29 PM
No, not really.  All the elements only offer linear scaling, some with an offset.  I can think of two options: