PLUS+1 User Forum
PLUS+1 Software => Communication => Topic started by: F.M.Elettromeccanica on May 10, 2020, 11:37:56 AM
-
Hi all,
Is there anyone who knows how change the ID of a CAN device?
I have 5 sensor with the same ID on my node, I should to change the ID to recognise every sensor.
Thanks in advance
-
There will probably be a specific procedure for the sensor you are using. This should be detailed in the documentation.
-
If it's CANOpen then it'll be done using the Layer Setting Services (LSS). Otherwise, as indicated above, it'll probably be some procedure from the manufacturer.
-
Thank you all,
Yes, looking into the documentation I found what you say.... Great.
Thanks again