PLUS+1 Hardware > Controllers

how to connect controller/computer

(1/1)

MimmoA:
Hello,
I'm new in Sawer-Danfoss device,
I have a simple ( maybe stupid ) doubth that is blocking me,
finally i ve my hardware,it's a controller MC050-010,but i dont know how to fisically connect it with my computer,
do I need any cable/wire to do this?
I read something about a GC 150 gateway,is this what i need?
Thank you so much
Regards

Brian Bandura:
Yes, you need a Canbus gateway of some sort, the CG150 is cheap and works well.  you build and compile your program, then download it to the controller with the gateway and service tool. You can also watch setpoints, change parameters with service tool.

Good luck!

Brian Bandura

Daniel:
Hi MimmoA

There is a free e-learning course available on Sauer-Danfoss' webpage, which could be a good start for you.
You can also sign up for a face to face training session where you will learn all fundamentals in how to use PLUS+1 GUIDE and Service Tool. On the link below you will find more information about dates and contacts for training sessions and also how to access the e-learning.

http://www.sauer-danfoss.com/Products/MobileElectronics/PLUS1Guide/PLUS1GuideSupport/PLUS1Training/index.htm


Best Regards
Daniel
PLUS+1™ HelpDesk

Navigation

[0] Message Index