Author Topic: Enable Signals all disappear when I add a new window..  (Read 3961 times)

bgtwuk

  • Guest
Enable Signals all disappear when I add a new window..
« on: April 08, 2012, 03:23:57 AM »

Using a DP610. and using many small windows to monitor a large vehicle.

All works well, but when I want to add another window, after I install the new enable signal, all the rest disappear.  If I catch it soon enough I can back out and they reappear.  But if I compile, they are lost.  

I have programmed three previous DP610 and it has happened quite a few times.


After further study, I found that if I tried to change the order by "move to top" or by hitting it with my mouse and inadvertantly changing its size, however little, all signals disappear.

Again if I close it down without saving and then reopen all is well.  Just don't allow it to auto save before that.

Bgtwuk
« Last Edit: April 08, 2012, 04:44:52 PM by bgtwuk »